Blunderbuss Designs - Shuriken Korean PCB

Korean levers can be a pain to wire up - it requires a 5 pin to 8 pin convertion harness, which can be messy and confusing for beginners.

This is where this PCB plate comes in, it will allow connection to the PCB via the Sanwa JLF 5 pin connector only, no more spaghetti of wires!

In addition, the PCB plate presses evenly down on the microswitches and eliminates the tilting of switches found in mass produced Korean levers.

The PCB is made from 2mm thick aluminuim for thta premium look and feel and is compatible with a wide range of popular Korean levers.

Supported microswitches are .187" / 4.8mm Omron V and Gersung A series microswitches.

Please review the manual for installation instructions (Link bellow).

Please note there is a slight white residute on the face of the PCB due to the soldering method used,

you can use a product called "Goo Gone" to clean it off if it bothers you.

Compatible levers:

- ASI Golden Lever (require shorter M4 bolts)

- Cool Bear Lever (requires longer M3x14mm bolts)

- Crown 303 and 309 series including CDP, Benylis and Helpme

- Alpha 49s

- Fujin V3

- Myoungshin Fanta (pre 2019, 2019 and late 2020)

- Sanjuks V5, V5C and V6

- Taeyoung Fanta